| |
Please
read through the instructions before starting
1. Secure the 2 necklaces with a rubber
band, as seen on the photo. The male and female part of the clasp
should be placed on the same ends (as shown on photo) |
|
| 2.
Start winding 1 of the necklaces |
|
3.
Wind the other necklace in the same direction |
|
| 4.
Twist the necklaces in the opposite direction of the wind (if you wind
the necklace to the right or clockwise, then twist the necklaces to
the left or counter clockwise). |
5.
When finished twisting, remove the clasp and rubber slide piece on
one of the necklaces. |
| 6.
On the other necklace, cut out a little portion of the rubber slide
piece, enabling the other necklace end to fit. |
7.
After the cut |
| |
|
| 8.
Slide the other necklace into the where the cut was made and use super
glue to hold it in place |
9.
Completed
26"→roughly 20"
22"→roughly 18" |
If
you use 2 x 26" necklace, it's going to be about 19.5 inch
If you use 2 x 22" necklace, it's going to be about 17.5 inch |
|
 |
|